![]() The device doesn’t have the expected settings, which prevents AXIS Companion from communicating with the device. Close the wizard and wait a few minutes before you restart it. ![]() ![]() The device is not available on the network after restarting, restoring or upgrading the firmware. Make sure you have internet connection and try again. Older Axis devices with a firmware that can’t be updated to 5.50 or later are not supported.ĪXIS Companion couldn’t contact the device. When you add your recorder to a site after a hard reset, you will be asked to type your encryption password to unlock the recorder, or to click Format disk to set a new password.Ĭheck that your devices have power and are connected to the same subnet as your computer. Reset your devices connected to the recorder. If no DHCP server is available on the network, the default IP address is 192.168.0.90 The product has been reset to the factory default settings. The process is complete when the status LED indicator turns green. Release the control button after 15-30 seconds when the LED indicator flashes amber.Ĭarefully put the recorder back in its place. Press and release the power button to start the recorder. Wait until the recorder is switched off, then turn it over to access the control button. Press the power button on the front of the recorder for 4-5 seconds until you hear a beep. A hard reset will not remove the encryption password.A hard reset will not remove your recordings.A hard reset will reset all the settings, including the IP address.
0 Comments
Leave a Reply. |